Take a compliant plug, measure its pins, and they will pass every gauge in the set. Put it in a socket and it may still need 60 N to seat. The difference is usually not the pin diameter. It is the 0.5 mm chamfer at the tip, and the radius on the socket entry that has to guide it.
Insertion force is the sum of three things: friction on the pin sides, the force needed to open the contact spring, and the force needed to correct misalignment. The chamfer is the only one of the three that acts before the pin touches the contact at all.
What the drawing actually specifies
| Feature | Typical value | What it controls |
| Pin width | 4.8 mm nominal for a 16 A pin | Fits the gauge and the socket bore |
| Pin thickness | 1.4 mm to 1.5 mm | Sets the contact pressure on the spring |
| Chamfer at the tip | 0.5 mm at 45 degrees, or a 0.5 mm radius | The lead-in that centres the pin |
| Corner radius, sides | 0.2 mm | Stops the pin shaving the socket entry |
| Insertion force, max | Tens of newtons, set by product class | The number the user feels |
| Withdrawal force, min | Fraction of the insertion force | The number that keeps the plug in |
A 45 degree chamfer of 0.5 mm moves the contact line back by half a millimetre and, more importantly, converts a square edge into a ramp. A square edge has to displace the spring by sheer force; a ramp converts part of the insertion force into opening the spring, and the ratio is set by the angle. At 45 degrees the mechanical advantage is modest. At 30 degrees it is better, and the pin is also weaker at the tip.
Why the socket side matters as much
Every socket has an entry: a funnel, a radius or a moulded lead-in in front of the contact. If that entry is generous, the plug can arrive at 3 degrees off axis and still seat. If it is a sharp rectangular hole, the chamfer on the pin has to do all the centring, and two hardened plastic edges meeting at an angle is a scraping action, not a guiding one.
This is why insertion force measured with a gauge and measured with a real plug differ. A gauge has no chamfer worth the name; it is made to maximum material to test the socket, not to simulate a plug.
The three things that raise force without changing the drawing
- Plating thickness. A pin at the top of its plating tolerance is a pin at the top of its size tolerance. Bright tin at 10 µm on a 4.8 mm pin adds 20 µm to the width, and that is the number the contact spring feels.
- Mould flash at the entry. A 0.1 mm flash line across the socket entry is a step the chamfer has to climb, and it is invisible on a drawing.
- Contact spring set. A spring that has taken a set after a few hundred insertions sits lower, so the same pin has to open it further. Force rises with age, not with size.
Measuring it honestly
Use a motorised rig at a fixed rate, typically a few millimetres per second, and record the peak of the force curve and the force at the fully seated position. The peak is the chamfer and the spring opening; the seated value is the friction. A plug whose peak is high and whose seated value is low has a sharp entry. A plug whose seated value is high has an oversized pin or a tight spring, and it will also fail withdrawal.
The rig needs a load cell in line with the pin axis, not a lever with a scale, because the peak lasts a fraction of a second. A plug and socket gauge set that includes a force fixture will do both the dimensional and the force check on the same sample, and the site index lists the adaptors for the common pin patterns.
Standards referenced: IEC 60884-1; IEC 61032.
